Console Redirection Submenu - NEC LS2400 User Manual

EMP Password: Anytime you attempt to initiate a
connection, a prompt for the user password appears. If you
never set up the EMP password, anyone can access the
EMP by clicking OK through the password prompt.
In the EMP Password area of the System Management
Submenu, type in a password of up to 8 alphanumeric
characters. If a beep is heard, the password was not
accepted and a different password must be entered.
EMP Access Modes: Choose either Disabled, Pre-boot, or
Always Active, depending on the type of EMP access
needed. The tables above show what is available with a
given setting.
EMP Restricted Mode Access: Set Restricted Mode to
either enabled or disabled as needed. If in enabled mode,
this means that the EMP Console's server control options,
Power On/Off and Reset, are unavailable. In disabled
mode, these same server control options are available.
EMP Direct Connect/Modem Mode: Select Direct Connect
if a null modem serial cable directly connects the server's
COM 2 port to the EMP Console client machine. If they are
connected via a modem, select Modem Mode.

Console Redirection Submenu

These settings in the Console Redirection Submenu of the
Server menu must be set exactly as noted to be able to use
the EMP.
COM Port Address: Select 2F8. This is the COM 2 port
that must be used by the EMP. The IRQ# setting
automatically populates with the correct number based on
the COM Port Address choice.
Baud Rate: Select 19.2k.
Console Type: Choose PC ANSI.
Flow Control: Choose CTS/RTS + CD.
C-8 Emergency management Port Console