NEC LS2400 User Manual page 115

1. Power off the system and remove the side panels as
described earlier in this chapter.
2. Remove the front panel, EMI shield, and filler panel
covering the bay into which you are installing a
peripheral device as described earlier in this chapter.
Observe static precautions. Use an antistatic
wrist strap.
3. Remove the device from its protective wrapper and place
it on an antistatic surface. Record the drive model and
serial number in the equipment log.
4. Set any drive jumpers or switches before you install the
drive. See the documentation that comes with the device
for jumper or switch information.
Note:
If the drive comes with drive rails, do
not use them. Remove any rails already
attached.
5. Slide the drive into the bay until the screw holes line up.
It may be necessary to temporarily loosen the mounting
screws on the already installed drives to position the
new drive. Secure the drive to the bay with the four
supplied screws.
! CAUTION
Upgrading Your System 4-39