NEC LS2400 User Manual page 63

Host SCSI ID
Scan Order
Removable media
support
CHS Mapping
3. Highlight the function you want to change and press
ENTER. You will be prompted to save changes when you
exit the configuration utility.
To change device configuration parameters, perform the
following steps:
1. At the SCSI Configuration Utility Main Menu, select the
adapter which connects to the SCSI device you are
reconfiguring. The first adapter listed controls the
operation of the hard disk drives; the second adapter
controls any SCSI removable media devices installed in
your system. Press ENTER.
2. Select "Device Selections" and press ENTER. The
Devices 0 to 7 screen displays.
3. Select the SCSI device you are reconfiguring and press
ENTER. If you are configuring SCSI Hard Disk Drives,
refer to the SYM53C875 Adapter 1 Table below; if you
are configuring SCSI Removable Media Devices, refer to
the SYM53C875 Adapter 2 Table below for
recommended settings.
SYM53C875 Adapter 1 – SCSI Hard Disk Drives
Description
Device Selections
Sync Rate
Width (bits)
7
Low to High
None
SCSI Plug and Play Mapping
Recommended Setting
or Display Only
Press ENTER for menu.
Select device and press
ENTER.
40
16
Your Configuration
Dev0 Dev1 Dev2
Configuring Your System 3-25
Dev3