NEC LS2400 User Manual page 89

2. If your system has one processor and you are adding a
second processor, then you must remove the
termination board in the empty Slot 1 secondary
connector. Press the tabs on the top of the termination
board bracket (A in figure) toward each other to release
them from the retention module. Lift the board bracket
and the terminator board (B) up and out of the retention
module, and store it appropriately.
B
A
Removing a Termination Board
3. If your system has one processor and you are replacing
it, leave the termination board intact in the empty Slot 1
secondary connector. Remove the processor you want to
replace. See "Removing the Pentium II Processor."
4. If your system has two processors and you are replacing
one or both, remove the appropriate one(s). See
"Removing the Pentium II Processor."
5. Remove the new processor from its antistatic package
and place it on a grounded, static-free surface or
conductive foam pad.
Upgrading Your System 4-13