Power Cable
6. Connect the signal and power cables to the drive as
shown in Figure 5-15. All device power cables are
labeled and must be installed in specific locations as
shown below:
Drive Location
A
B (Tape)
C (CD-ROM)
D (Diskette)
7. Replace the front panel and side panels, and power on
the system.
Removing a 5.25-Inch Device
1. Power off the system and remove the side panels as
described earlier in this chapter.
2. Remove the front panel as described earlier in this
chapter.
4-40 Upgrading Your System
Installing a Removable Media Device
Power Connector
P5
P3
P6
5.25" Drive