Cd-Rom Drive Activity Light Does Not Light - NEC LS2400 User Manual

T
Are all relevant switches and jumpers on the hard drive
and adapter board set correctly?
T
Is the hard disk drive properly configured in the SSU?
Run the SSU to make sure that the hard disk drive is
configured with the correct parameters. For information
about running the SSU, refer to the "Configuring Your
System" chapter.
If the problem persists, there may be a problem with the
hard disk drive, the optional controller board, system
board, drive signal cable, or LED connector. Contact your
service representative for assistance.
Note: The hard disk drive activity
light on the front panel lights when a
hard disk drive, or a SCSI device
controlled by the onboard SCSI host
controller, is in use. This LED does not
display CD-ROM activity.

CD-ROM Drive Activity Light Does Not Light

Check the following:
T
Is the power and signal cable to the CD-ROM drive
properly installed?
T
Are all relevant switches and jumpers on the drive set
correctly?
T
Is the drive properly configured?
T
Is the onboard IDE controller enabled?
5-18 Problem Solving