Removing An Internal Hard Disk Drive - NEC LS2400 User Manual

Removing an Internal Hard Disk Drive

1. Power off the system and remove the left side panel as
described earlier in this chapter.
2. Disconnect the signal and power cables from the back of
the drive. It is necessary to completely remove the cables
from all the drives before the drive can be removed.
3. Remove the two screws holding the 3.5-inch drive bay to
the chassis.
4. Swing the drive bay out of the chassis.
5. Slide the drive bay towards the top of the chassis until
the tabs on the bay are free from the chassis. Remove
the drive bay from the chassis and place it on an
antistatic surface.
6. Remove the hard disk drive by removing the four screws
that secure the drive to the drive bay.
Cabling the Disk Drives
1
2
3
4
Upgrading Your System 4-31