Problems With Application Software; Press F2 Key To Enter Setup: Prompt Does Not Display - NEC LS2400 User Manual

Note: Front panel hard disk LED
indicates IDE and SCSI devices: The hard
disk drive activity light on the front panel lights
when either an IDE hard disk drive, or a SCSI
device controlled by the onboard SCSI host
controller, is in use. This LED does not display
CD-ROM activity.

Problems with Application Software

If you have problems with application software, perform the
following:
T
Verify that the software is properly configured for the
system. Refer to the software installation and operation
documentation for instructions on setting up and using
the software.
T
Verify a different copy of the software to see if the
problem is with the copy that you are using.
T
Make sure all cables are installed correctly.
T
Verify that the system board jumpers are set correctly.
Refer to the "Configuring Your System" chapter for
jumper settings.
T
If other software runs correctly on the system, contact
your vendor about the failing software.
If the problem persists, contact the software vendor's
customer service representative for assistance.

Press F2 Key to Enter Setup: Prompt Does Not Display

If the prompt "Press F2 key to run Setup" does not appear
at system startup, then the prompt option has been
disabled in the SSU. There are two ways to enable the
prompt:
Problem Solving 5-19