Running New Application Software - NEC LS2400 User Manual

T
Are all DIMMs fully seated and installed correctly? Refer
to the "Upgrades and Options" chapter for installation
instructions?
T
Are all option boards and disk drives installed correctly?
Refer to the "Upgrades and Options" chapter.
T
Is the system hard disk drive properly formatted or
defined?
T
Is the operating system properly loaded? Refer to the
operating system documentation.
T
Are all drivers properly installed? For information about
installing drivers, refer to your Network Operating
System Configuration Guide.
T
Are the configuration settings in BIOS Setup and the
System Setup Utility (SSU) correct? For information
about running these utilities, refer to the "Configuring
Your System" chapter.
If the above items are all correct, but the problem reoccurs,
refer to "Additional Troubleshooting Procedures" in this
chapter.

Running New Application Software

Problems that occur when you run new application
software are usually related to the software. Faulty
equipment is much less likely, especially if other software
runs correctly. If you have problems while running new
application software, check the following:
T
Does the system meet the minimum hardware
requirements for the software? Refer to the software
documentation.
T
Is the software an authorized copy? Unauthorized copies
often do not work. Obtain an authorized copy of the
software.
Problem Solving 5-5