Setting Up The Server For The Emp; System Management Submenu - NEC LS2400 User Manual

Server Configuration: The EMP Console requires the
server's COM 2 port to be connected to an external modem
or directly connected to a serial cable.
Direct Connect Configuration: A null modem serial cable
is needed. Connect one end of the cable into the COM 2
port of server and the other into a port on the client
machine.
Modem Configuration: On the client, the EMP Console
uses the Windows Application Program Interface (API) to
determine if a modem is connected and available. The EMP
Console does not configure the modem; it should be
preconfigured through Windows.
For modem support, the server must use a Hayes
compatible 14400 bps modem. The modem must be on the
NT Hardware Compatibility List provided by Microsoft. The
server modem must be set in auto-answer mode for the
EMP Console to be able to connect to it.

Setting Up the Server for the EMP

To use the EMP, you must configure the server's BIOS with
specific settings. These settings take place in two
submenus of the BIOS Server menu, the System
Management Submenu and the Console Redirect
Submenu. The earlier BIOS settings section shows all
available options. This section focuses on those settings
that must be configured to use the EMP.

System Management Submenu

All EMP related settings occur from the System
Management Submenu of the Server main menu. Change
only the items below; all other default settings should
remain the same.
Emergency management Port Console C-7