Optional Raid Controller - NEC LS2400 User Manual

Optional RAID Controller

Factory Installed Controller
One of the options available for your system is the single
channel AMI MegaRAID E
which gives your system the added security of fault
tolerance.
If you order a system with the RAID controller, the system
is pre-configured at the factory. Refer to the "RAID
Configurations" table to determine how the RAID controller
was configured at the factory. If you want to reconfigure
disk arrays and logical drives, you must run the MegaRAID
E
XPRESS
RAID level, you must run the Power Console Utility. Refer
to the MegaRAID E
your system for information on running the MegaRAID
E
XPRESS
Add-on Controller
If you are adding the RAID controller to an existing system,
the MegaRAID E
configure disk arrays and logical drives in your system.
Since the utility resides in the MegaRAID E
the RAID controller, its operation is independent of the
operating system in your server. Refer to Chapter 4 in this
User's Guide for information on installing an add-in option
board. Refer to Chapter 2 of the MegaRAID E
SCSI Disk Controller Configuration Software Guide for
information on running the MegaRAID E
Utility.
3-28 Configuring Your System
XPRESS
BIOS Setup Utility; if you want to change the
documentation included with
XPRESS
BIOS Setup Utility and the Power Console Utility.
BIOS Setup Utility allows you to
XPRESS
® 762 Controller board,
BIOS on
XPRESS
XPRESS
BIOS
XPRESS
PCI