Removable Media Devices - NEC LS2400 User Manual

Removable Media Devices

A variety of IDE and SCSI removable media devices can be
installed in peripheral bays A, B, and C. An IDE CD-ROM
is always mounted in bay C. A 3.5-inch diskette drive is
always mounted in bay D. Other devices should be installed
in the first available bay from the top (bay A). Contact your
sales representative or dealer for a list of approved devices.
BAY A
BAY B
BAY C
BAY D
If you are adding or removing an IDE removable media
device, consider the following:
T
The system board supports a primary and secondary IDE
channel connector. Each of these supports two devices,
for a total of four IDE devices. Your system includes he
primary channel IDE interface cable.
T
A first (master) device and a second (slave) device are
supported on both the primary and secondary IDE
connector. The device configuration, master versus slave,
is determined by jumpers on the device. Cable Sense (CS)
device configuration is not supported.
T
Your system includes a three-connector IDE cable
connecting the CD-ROM to the system board primary
IDE connector. The CD-ROM that comes with your
system is set as the master device. A second IDE connect
is available to connect a slave IDE removable media
device.
Upgrading Your System 4-37