NEC LS2400 User Manual page 138

12. Select Step 4, Save Configuration. Once you select this
step, the changes are immediately saved into an INF file,
a CMS file, and nonvolatile memory.
13. Press Esc to exit the SSU. You will be prompted to
reboot the system or simply exit to the command line
prompt. You'll need to reboot the system to let your
changes take effect, but first remove the SSU diskette
drive. Then press F10 to reboot.
You should now see the F2 prompt displayed at bootup.
Enable F2 Prompt by Changing a Jumper and Using SSU
If you do not have an SSU diskette or CD available, you can
clear CMOS memory to enable the F2 prompt. This means
you must change a jumper on the system board, run the
SSU, save your changes, and change the jumper back to
the default setting.
Note: This procedure resets all to default
settings: Clearing CMOS memory resets all
SSU and Setup settings to their defaults, not
just the CMOS CLR setting. Before proceeding,
check that you have a backup paper copy of
configuration. Referring to the worksheets
could make your reconfiguration task easier.
1. Observe the safety and ESD precautions stated at the
beginning of this chapter.
2. Turn off all connected peripherals, turn off system
power, and disconnect the AC power cord.
3. Remove the side cover. Refer to the "Upgrades and
Options" chapter for information on removing the side
cover. You do not need to remove the system board from
the chassis, and you probably do not need to remove
any add-in boards.
Problem Solving 5-21