Removing An Internal Hard Disk Drive - NEC ES1200 User Manual

5-24

Removing an Internal Hard Disk Drive

Upgrades and Options
Figure 5-11. Cabling the Disk Drives
1. Power off the system and remove the left side panel
as described earlier in this chapter.
2. Disconnect the signal and power cables from the back
of the drive (Figure 5-11). It is necessary to
completely remove the cables from all the drives
before the drive can be removed.
3. Remove the two screws holding the 3.5-inch drive bay
to the chassis (Figure 5-10).
4. Swing the drive bay out of the chassis.
5. Slide the drive bay towards the top of the chassis
until the tabs on the bay are free from the chassis.
Remove the drive bay from the chassis and place it
on an antistatic surface.
6. Remove the hard disk drive by removing the four
screws that secure the drive to the drive bay.