Sun Visor Light; Jump-Starting - Seat Exeo 2012 Owner's Manual

280 If and when

Sun visor light

– Remove the bulb carefully, using the flat part of a screwdriver
⇒ f ig.
224.
– Use a screwdriver to remove the protective cover.
– Remove the bulb, moving it in the direction of the arrow and
outwards

Jump-starting

Jump leads
The jump lead must have a sufficient wire cross section.
If the engine fails to start because of a discharged battery, the battery can
Fig. 224 Removing sun
be connected to the battery of another vehicle to start the engine.
visor light
Jump leads
Jump leads must comply with standard DIN 72553 (see manufacturer's doc-
umentation). The wire cross section must be at least 25 mm
gines and at least 35 mm
Note
● The vehicles must not touch each other, otherwise electricity could flow
as soon as the positive terminals are connected.
● The discharged battery must be properly connected to the vehicle elec-
trical system.
Fig. 225 Removing sun
visor light
⇒ f ig.
225.
2
for diesel engines.

2
for petrol en-
