Seat Exeo 2012 Owner's Manual page 265

Changing the dipped beam headlight bulb
The procedure for changing the bulb is the same on both
sides.
– Switch off the ignition and the lights.
Safety First
Fig. 193 Dipped beam
headlights
Fig. 194 Dipped beam
headlights
Operating Instructions
– Raise the bonnet.
⇒ f ig. 193
– Move the brace
remove the rigid cover, separating the brace side and then re-
moving the two tabs from the other end of the cover.
⇒ f ig. 194
– Pull the connector
⇒ f ig. 194
– Unclip the retainer spring
right.
– Remove the bulb and fit the new one in the headlight casing
with the tab upwards, starting to position it from below.
– Clip on the spring, raising it and pressing it slightly while turn-
ing it anti-clockwise. To ensure correct lighting, the filament
must be vertical. When changing the bulb, you can check the
position of the bulb through the headlight glass.
– Connect the connector to the bulb.
– Fit the cover, first inserting the side tabs and then closing the
cover and the brace. Make sure that the gasket sits well on the
casing cover during the operation.
– Check whether the new bulb is working.
– Have the headlight settings checked as soon as possible.
Practical Tips
If and when
in the direction of the arrow and
1
from the bulb.
2
pressing inwards to the
3
Technical Specifications
263
