Seat Exeo 2012 Owner's Manual page 264

262 If and when
Note
Although it is not necessary, previously remove the rigid cover
easier turn signal bulb changes.
Changing the main headlight bulb
The procedure for changing the bulb is the same on both
sides.
⇒ f ig. 193
for

– Switch off the ignition and the lights.
– Raise the bonnet.
– Pull up on the rubber cover
– Remove the connector
– Press the spring
Fig. 191 Main beam
– Remove the bulb. pulling it from the connection terminal and
headlights
fitting fit the replacement so that it sits correctly in the cut-out
on the reflector. To ensure correct lighting, the filament must be
vertical. When changing the bulb, you can check the position of
the bulb through the headlight glass.
– Installation is in reverse order, ensuring that the rubber cover is
well fitted to the housing.
– Check whether the new bulb is working.
– Have the headlight settings checked as soon as possible.
Fig. 192 Main beam
headlights
⇒ f ig. 191
to remove it.
A
⇒ f ig. 192
from the bulb.
1
⇒ f ig. 192
inwards and to the right.
2
