Seat Exeo 2012 Owner's Manual page 176

174 Driving
Setting the speed
The desired cruising speed has to be stored in the memory.
– Drive at the desired speed.
– Pull the lever to position
A
tem.
– Briefly press button
When button is released, the current speed is stored in the memory and
B
the vehicle will then maintain this speed.
Fig. 140 Controls for the
cruise control system
⇒ f ig. 140
to activate the sys-
1
.
B
Adjusting the stored speed
The desired cruising speed can be adjusted up or down as
required.
Acceleration
– Move the lever up towards
A
– Release the lever to store the current cruising speed.
Deceleration
– Move the lever down towards
A
– Release the lever to store the current cruising speed.
Pressing lever briefly
A
– You can increase the set speed in steps of 2 km/h by briefly
pressing the lever up towards
A
– You can decrease the set speed in steps of 2 km/h by briefly
pressing the lever down towards
A
You can also use the accelerator pedal momentarily to increase speed. The
previously programmed speed will be automatically resumed when the ac-
celerator pedal is released.
 However, if the vehicle exceeds the programmed speed by more than 10
km/h for more than 5 minutes, the programmed speed will be deleted. You
will then need to enter the speed again.
⇒ f ig. 140
.
+
⇒ f ig. 140
.
-
⇒ f ig. 140
.
+
⇒ f ig. 140
.
-
