Seat Exeo 2012 Owner's Manual page 88

86 Cockpit
Driving time warning
After 2 hours of continuous driving, the display automatically switches over
to the driving time display of
starts flashing. This is to remind the driver to take a break.
The driving time warning can be switched off by briefly pressing the func-
tion selector switch or the
If you continue driving or take a break for less than 10 minutes, the driving
time warning will switch on once again when the total driving time is
hours, 6:00 hours, etc. However, if you take a break for more than 10 mi-
nutes, the driving time warning clock will be erased.
Distance covered
This display shows the distance you have covered since the memory was
last cancelled. The longest possible distance which can be recorded is
9999.9 km.
Note
● The displays for fuel consumption (average and instantaneous), dis-
tance to empty and speed are shown in metric units.
● The information in the memory is lost if the battery is disconnected.
2:00 . At the same time the driving time display
⇒ f ig.
button 60.
Reset
Operation
The onboard computer is controlled by means of two
switches on the windscreen wiper lever.
4:00
Activating the onboard computer

– Press the reset button
er (memory 1 or 2)
Selecting the function
– Press the top or bottom of the function selector switch
⇒ f ig.
60. This displays the functions of the onboard computer
in sequence.
Resetting to zero
– Press and hold the Reset button
The following values can be reset to zero using the Reset button:
Fig. 60 Windscreen wip-
er lever: Onboard com-
puter controls
repeatedly until the onboard comput-
B
⇒ f ig. 59
is displayed.
for at least two seconds.
B
A
