Seat Exeo 2012 Owner's Manual page 241

Tyre service life
The service life of tyres is dependent on tyre pressure, driv-
ing style and fitting.
Safety First
Fig. 174 Tyre tread wear
indicators
Fig. 175 Diagram for
changing wheels
Operating Instructions
Wear indicators
The original tyres on your vehicle have 1.6 mm high "tread wear indicators"
⇒ f ig.
174, running across the tread. Depending on the make, there will be
6 to 8 of them evenly spaced around the tyre. Markings on the tyre sidewall
(for instance the letters "TWI" or other symbols) indicate the positions of
the tread wear indicators. The minimum tread depth required by law is
1.6 mm (measured in the tread grooves next to the tread wear indicators).
Worn tyres must be replaced. Different figures may apply in export countries
⇒
.
Tyre pressure
Under-inflation or over-inflation will reduce the life of the tyres considerably
and also impair the vehicle's handling. The inflation pressures are listed on
a sticker on the inside of the fuel tank flap.
Correct inflation pressures are very important, especially at high speeds.
The pressure should therefore be checked at least once a month and before
starting any long journey.
Tyre pressure monitoring (RKA+)*
Monitoring of the tyre pressures is based on the tyre pressures you have
stored. The tyre pressure monitoring system cannot function as intended if
you store tyre pressure settings for a normal load, but then drive with the
vehicle fully laden. The tyre pressure must be adapted to the actual load
and stored accordingly in the tyre pressure monitoring system ⇒ p age 237.
Driving style
Fast cornering, heavy acceleration and hard braking all increase tyre wear.
Changing wheels around
If the front tyres are worn considerably more than the rear ones it is advisa-
ble to change them around as shown
for about the same time.
Practical Tips
Wheels and tyres
⇒ f ig.
175. All the tyres will then last
Technical Specifications
239
