Seat Exeo 2012 Owner's Manual page 273

Remove the bulb holder
When changing a bulb, you must first remove the bulb hold-
er.
There are three securing tabs on the inside of the tail light.
– Release the retaining tabs
– Take out the bulb holder.
– Change the defective bulb ⇒ p age 271 ⇒ p age 272.
WARNING
If a bulb is replaced in a tail light assembly with LED, do not pull too hard
on the bulb holder. This may damage the wiring of the LED module.
Safety First
Fig. 208 Retaining tabs
on reverse side of tail
light
⇒ f ig. 208
.
A
Operating Instructions
Changing bulbs
All bulbs can be changed easily in the bulb holder.
The bulbs are secured with a bayonet fastener. The table below
gives an overview of the bulb positions.
– Lightly press the defective bulb into the bulb holder, then turn it
to the left and remove it.
– Fit the new bulb, pressing it into the bulb holder and turn it to
the right as far as it will go.
– Use a cloth to remove any fingerprints from the glass part of the
bulb.
– Check whether the new bulb is working.

– Re-install the bulb holder ⇒ p age 272.
Practical Tips
If and when
Fig. 209 Position of the
bulbs in the bulb holder.
Example: Left tail light in
side panel

Technical Specifications
271