Seat Exeo 2012 Owner's Manual page 266

264 If and when
Changing the side light bulb (outside of vehicle)
The procedure for changing the bulb is the same on both
sides.
– Switch off the ignition and the lights.
– Raise the bonnet.
– Move the brace
remove the rigid cover, separating the brace side and then re-
moving the two tabs from the other end of the cover.
– Gently press on the bulb holder tabs
cover upwards (it can also be removed by pulling on the bulb
holder wires).
– Separate the bulb from the bulb holder by pulling both pieces
anti-clockwise.
– Fit the new bulb by pressing on the bulb holder.
– Insert the bulb into the socket and press on the bulb holder. Fit
the cover, first inserting the side tabs and then closing the cov-
er and the brace. Make sure that the gasket sits well on the cas-
Fig. 195 Side light bulb
ing cover during the operation.
(outside of vehicle)
– Check whether the new bulb is working.
Fig. 196 Side light bulb
(outside of vehicle)
⇒ f ig. 195
in the direction of the arrow and
1
⇒ f ig. 196
and pull the
