Seat Exeo 2012 Owner's Manual page 274

272 If and when
Position of the bulbs
Pos.
Bulb function
⇒ f ig. 209
A Brake light and side light
B Side lights
C Turn signal
Changing bulbs. LED lamps
All bulbs can be changed easily in the bulb holder.
The bulb is secured with a bayonet fastener. The table below gives
an overview of the bulb positions.
– Lightly press the defective bulb into the bulb holder, then turn it
to the left and remove it.
– Fit the new bulb, pressing it into the bulb holder and turn it to
the right as far as it will go.
– Use a cloth to remove any fingerprints from the glass part of the
P21W LL
bulb.
P21W LL
– Check whether the new bulb is working.
PY21W

– Re-install the bulb holder ⇒ p age 272.
Position of the bulbs
Pos.
⇒ f ig. 210
Note
● It is only possible to change the turn signal light.
● If the brake light and/or side lights with LEDs have to be replaced, the
tail light must be replaced.
Fitting the bulb holder
Fig. 210 Position of the
The bulb holder is easy to fit.
bulb on the bulb holder.
Example: Left tail light in
side panel
– Position the bulb holder on the tail light and align it so that it is
securely seated.
– Press the bulb holder into the tail light until it engages.
– Re-install the tail light unit ⇒ p age 273.
Bulb function
A Turn signal PY21W

