Fastening The Cabinet To The Floor And Roof/Wall (Marine Units) - ABB ACS880-07 Hardware Manual

Fastening the cabinet to the floor and roof/wall (marine
units)
Follow the general rules given in section
See the dimension drawing delivered with the drive for the locations of the fastening holes
in the flat bars below the cabinet and for fastening points at the top of the cabinet. Top
fastening brackets are included in the delivery.
Fasten the cabinet to the floor and roof (wall) as follows:
1. Bolt the unit to the floor through the holes in each flat bar at the base of the cabinet
using M10 or M12 screws.
2. If there is not enough room behind the cabinet for installation, clamp the rear ends of
the flat bars.
3. Remove the lifting lugs and bolt the fastening brackets into the lifting lug holes. Fasten
the top of the cabinet to the rear wall and/or roof with brackets.
2
b
a
c
General rules on page 59.
d
3
M16
Mechanical installation 61
2. Clamping the cabinet to the
floor at the back
a Clamp
b Back panel of cabinet
c Flat bars at base of cabinet
3. Fastening the cabinet at the
top
d Fastening bracket