Installing Option Modules; Mechanical Installation Of I/O Extension, Fieldbus Adapter And Pulse Encoder; Interface Modules; Wiring I/O Extension, Fieldbus Adapter And Pulse Encoder Interface Modules - ABB ACS880-07 Hardware Manual

Installing option modules

Mechanical installation of I/O extension, fieldbus adapter and pulse

encoder interface modules
See page 39 for the available slots for each module. Install the option modules as follows:
WARNING! Obey the instructions in chapter
them, injury or death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section
16 before you start the work.
2. Frames R6 to R9: Open the swing-out frame.
3. Insert the module carefully into its position on the control unit.
4. Fasten the mounting screw. Note: The screw tightens the connections and grounds
the module. It is essential for fulfilling the EMC requirements and for proper operation
of the module.
Wiring I/O extension, fieldbus adapter and pulse encoder interface

modules
See the appropriate option module manual for specific installation and wiring instructions.
Electrical installation 113
Safety instructions. If you ignore
Precautions before electrical work on page