Ul Checklist; Csa Marking; C-Tick" Marking; Gost-R Certificate Of Conformity - ABB ACS880-07 Hardware Manual

UL checklist


•
The drive is to be used in a heated, indoor controlled environment. The drive must be
installed in clean air according to enclosure classification. Cooling air must be clean,
free from corrosive materials and electrically conductive dust. See page 192.
•
The maximum ambient air temperature is 40 °C (104 °F) at rated current. The current
is derated for 40 to 50 °C (104 to 122 °F).
•
The drive is suitable for use in a circuit capable of delivering not more than 100,000
rms symmetrical amperes, 600 V maximum when the input cable is protected with
class T fuses. The ampere rating is based on tests done according to UL 508A.
•
The cables located within the motor circuit must be rated for at least 75 °C (167 °F) in
UL-compliant installations.
•
The input cable must be protected with fuses. Circuit breakers must not be used
without fuses in the USA. For suitable circuit breakers, contact your local ABB
representative. Suitable IEC (class aR) fuses for drive protection are listed on page
179 and UL fuses on page 180.
•
For installation in the United States, branch circuit protection must be provided in
accordance with the National Electrical Code (NEC) and any applicable local codes.
To fulfill this requirement, use the UL classified fuses.
•
For installation in Canada, branch circuit protection must be provided in accordance
with the Canadian Electrical Code and any applicable provincial codes. To fulfill this
requirement, use the UL classified fuses.
•
The drive provides overload protection in accordance with the National Electrical Code
(NEC).

CSA marking

CSA marking is pending for the drive.w

"C-tick" marking

C-tick marking is pending for the drive.
"C-tick" marking is required in Australia and New Zealand. A "C-tick" mark is attached to
each drive in order to verify compliance with the relevant standard (IEC 61800-3:2004,
Adjustable speed electrical power drive systems – Part 3: EMC product standard including
specific test methods), mandated by the Trans-Tasman Electromagnetic Compatibility
Scheme.
For fulfilling the requirements of the standard, see section
3:2004.

GOST-R certificate of conformity

The drive has been given a GOST-R certificate of conformity.
Technical data 201
Compliance with the EN 61800-