Maintenance 173
Replacing the control panel battery
The battery is housed on the rear of the control panel. Replace with a new CR 2032
battery. Dispose the old battery according to local disposal rules or applicable laws.
Replacing the control unit battery
1. Stop the drive and do the steps in section
Precautions before electrical work
on page
16
before you start the work.
To replace the control unit battery:
1. Remove the M4x8 (T20) screws at the ends of the control unit.
2. To see the battery, remove the XD2D terminal block.
3. Carefully lift the edge of the control unit cover on the side with the I/O terminal blocks.
4. Carefully pull the battery out of the battery holder.
5. Carefully put a new CR2032 battery into the battery holder.
6. Close the control unit cover.
7. Tighten the M4×8 (T20) screws.
8. Install the XD2D terminal block.
Memory unit
When a drive is replaced, the parameter settings can be retained by transferring the
memory unit from the defective drive to the new drive. The memory unit is located on the
control unit, see page
120
or 130.