54 Mechanical installation
Note: For easy maintenance, do not install the drives of frames R10 and R11 on a higher
level than the floor in front of it. Otherwise the ramp supplied with the drive cannot be used
when replacing the drive modules that run on wheels.
Necessary tools
The tools required for moving the unit to its final position, fastening it to the floor and wall
and tightening the connections are listed below:
•
crane, fork-lift or pallet truck (check load capacity!), iron bar, jack and rollers
•
Pozidriv and Torx (2.5...6 mm) screwdrivers
•
torque wrench
•
set of wrenches or sockets.