Installation Of Safety Functions Modules (Frames R10 And R11); Case 1: Fso-Xx Safety Functions Module On Slot 2 - ABB ACS880-07 Hardware Manual

installation of safety functions modules (frames R10 and R11)


Install the safety functions module next to the control unit as described below. Change the
mounting plate of the module as shown in FSO-11 user's manual (3AUA0000097054
[English]).
WARNING! Obey the instructions in chapter
them, injury or death, or damage to the equipment can occur.

Case 1: FSO-xx safety functions module on Slot 2

1. Stop the drive and do the steps in section
16 before you start the work.
2. Connect the FSO-xx data cable to connector X12 on the control unit.
3. Fasten the FSO-xx safety functions module to Slot 2 with four screws.
4. Tighten the FSO-xx electronics grounding screw. Note: The screw tightens the
connections and grounds the module. It is essential for fulfilling the EMC requirements
and for proper operation of the module.
5. Connect the FSO-xx data cable to FSO-xx connector X110.
6. Connect the Safe torque off four-wire cable to connector X111 on the module and to
connector XSTO on the drive module control unit.
7. Connect the external +24 V power supply cable to connector X112.
8. Connect the other wires as shown in FSO-11 user's manual (3AUA0000097054
[English]).
Electrical installation 115
Safety instructions. If you ignore
Precautions before electrical work on page