Cannot Print Over A Network; Cannot Connect The Printer To The Network; Cannot Print Over A Tcp/Ip Network; Cannot Print Over A Netware Network - Canon imagePROGRAF iPF6400SE User Manual

iPF6400SE

Cannot print over a network

Cannot print over a network

Cannot connect the printer to the network ........................................................................................................... 631

Cannot print over a TCP/IP network ..................................................................................................................... 631

Cannot print over a NetWare network ................................................................................................................... 631

Cannot print over AppleTalk or Bonjour networks ................................................................................................. 632
Cannot connect the printer to the network
Cannot connect the printer to the network
Cause
The Ethernet cable is
1.
not connected cor-
rectly to the printer's
2.
Ethernet port.
Cannot print over a TCP/IP network
Cannot print over a TCP/IP network
Cause
The printer's IP address is not configured
correctly.
The printer's TCP/IP network settings are not
configured correctly.
The computer you are trying to print from is
not configured correctly.
Cannot print over a NetWare network
Cannot print over a NetWare network
Cause
The printer's NetWare settings
are not configured correctly.
The computer you are trying to
print from is not configured cor-
rectly.
The NetWare server and serv-
ices are not configured correctly.
User's Guide
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer
on. For instructions on connecting the cable, refer to the Setup Guide.
Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100 Base-TX and orange if connected via 10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the hub is on.
•
Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
•
Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission rate automatically
(in auto negotiation mode), sometimes the hub settings cannot be detected. In this case, configure the
connection method manually, specifying the communication mode in use.
(See "Configuring the Communication Mode Manually.")
Make sure the printer's IP address is configured correctly.
(See "Configuring the IP Address Using imagePROGRAF Device Setup Utility.")
(See "Configuring the IP Address Using the Printer Control Panel.")
Make sure the printer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.")
Make sure the computer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer Driver Destination (Windows).")
(See "Configuring the Destination in TCP/IP Networks (Mac OS).")
Make sure the printer's NetWare settings are configured correctly. In particular, make sure a valid
frame type is selected.
(See "Configuring the Printer's NetWare Network Settings With RemoteUI.")
Make sure the computer's NetWare settings are configured correctly.
(See "Configuring NetWare Network Settings.")
Check the following points.
1.
Make sure the NetWare file server is running.
Cannot connect the printer to the network
Corrective Action
P.525
➔
Corrective Action
Corrective Action
P.513
➔
P.527
➔
P.505
➔
P.509
➔
P.508
➔
P.521
➔
P.518
➔
631