Canon imagePROGRAF iPF6400SE User Manual page 479

iPF6400SE
Mainte-
Replace P.head
nance
Repl. maint cart
Clear remain pcs
Head Info
Clean Platen
Interface EOP Timer
Setup
TCP/IP IPv4
IPv6
NetWare NetWare
Frame Type
User's Guide
Setting Item
IPv4 Mode
Protocol DHCP
BOOTP
RARP
IPv4 IP Address
Settings
Subnet Mask
Default G/W
DNS DNS Dync update
Settings
Pri. DNS SrvAddr
Sec. DNS SrvAddr
DNS Host Name
DNS Domain Name
IPv6 Support
IPv6 StlessAddrs
DHCPv6
DNS DNS
Settings Dync
update
Pri. DNS SrvAddr
Sec. DNS SrvAddr
DNS Host Name
DNS Domain Name
Description, Instructions
Execute when replacing the Printhead. Follow the instruc-
tions displayed to complete the required procedure. (See
"Replacing the Printhead.")
Not displayed during a warning message that the remaining
Maintenance Cartridge capacity is low.
Execute when replacing the Maintenance Cartridge. Follow
the instructions displayed to complete the required proce-
dure. (See "Replacing the Maintenance Car-
tridge.")
P.585
➔
This process is needed if there are any scraps left in the
Paper Feed Slot. (See "Clearing Jammed Paper (Paper
Feed Slot).")
P.616
➔
Indicates information about the printhead.
Move the Carriage in preparation for cleaning the Platen.
Specify the timeout period before cancellation of print jobs
that cannot be received by the printer.
Choose whether the printer IP address is configured auto-
matically or a static IP address is entered manually.
Specify the protocol used to configure the IP address auto-
matically.
Specify the printer network information when using a static
IP address.
Enter the IP address assigned to the printer, as well as the
network subnet mask and default gateway.
The value that was automatically configured is displayed if
you have set IPv4 Mode to Automatic.
Specify whether DNS server registration is updated auto-
matically.
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify whether to connect via IPv6.
Specify whether a IPv6 stateless address is used.
Specify whether DHCPv6 settings are used.
Statefull Specify whether DNS server registration is updated auto-
Addr matically.
State-
less
Addr
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify the NetWare protocol. To apply your changes,
choose Register Setting.
Specify the frame type to use.
Menu Settings
P.578
➔
479