Configuring The Maximum Number Of Ipv6 Multicast Groups That An Interface Can Join; Adjusting Mld Performance; Configuration Prerequisites - HP A5500 SI Switch Series Configuration Manual

To do...
Configure an IPv6 multicast group
filter
Configuring the maximum number of IPv6 multicast groups that
an interface can join
Follow these steps to configure the maximum number of IPv6 multicast groups an interface can join:
To do...
Enter system view
Enter interface view
Configure the maximum number of IPv6
multicast groups that the interface can
join
NOTE:
This configuration takes effect for dynamically joined IPv6 multicast groups but not the statically
configured multicast groups.

Adjusting MLD performance

NOTE:
In MLD view, the configuration is globally effective. In interface view, the configuration is effective only
on the current interface.
If the same function or parameter is configured in both MLD view and interface view, the
configuration performed in interface view has priority, regardless of the configuration order.

Configuration prerequisites

Before you adjust MLD performance, complete the following tasks:
Configure any IPv6 unicast routing protocol so that all devices in the domain can be interoperable
•
at the network layer
Configure basic functions of MLD
•
Determine the startup query interval
•
Determine the startup query count
•
Determine the MLD query interval
•
Determine the MLD querier's robustness variable
•
Use the command...
mld group-policy acl6-number [
version-number ]
Use the command...
system-view
interface interface-type interface-
number
mld group-limit limit
311
Remarks
Required
By default, no IPv6 group filter is
configured on the interface. That
is, hosts on the current interface
can join any valid multicast
group.
Remarks
—
—
Required
1000 by default.