HP A5500 SI Switch Series Configuration Manual page 277

Figure 67 Network diagram for static port configuration
Source
1::1/64
Configuration procedure
Enable IPv6 forwarding and configure IPv6 addresses
1.
Enable IPv6 forwarding and configure an IPv6 address and prefix length for each interface according to
Figure 67.
Configure Router A
2.
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD on
GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] pim ipv6 dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim ipv6 dm
[RouterA-GigabitEthernet1/0/2] quit
Configure Switch A
3.
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to this VLAN, and
enable MLD snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/3
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] quit
GE1/0/2 GE1/0/1
1::2/64 2001::1/64
Router A
MLD querier
Switch C
GE1/0/5
Host C
Receiver
Host B
Switch A
GE1/0/1
GE1/0/2 GE1/0/2
Switch B
Host A
Receiver
265