Enabling Mld; Configuring The Mld Version - HP A5500 SI Switch Series Configuration Manual

Determine the ACL rule for IPv6 multicast group filtering
•
Determine the maximum number of IPv6 multicast groups that can be joined on an interface
•

Enabling MLD

Enable MLD on the interface on which IPv6 multicast group memberships will be created and
maintained.
Follow these steps to enable MLD:
To do...
Enter system view
Enable IPv6 multicast routing
Enter interface view
Enable MLD
NOTE:
For more information about the multicast ipv6 routing-enable command, see the
Command Reference

Configuring the MLD version

Because MLD message types and formats vary with MLD versions, the same MLD version should be
configured for all routers on the same subnet before MLD can work properly.
Configuring an MLD version globally
Follow these steps to configure an MLD version globally:
To do...
Enter system view
Enter MLD view
Configure an MLD version
globally
Configuring an MLD version on an interface
Follow these steps to configure an MLD version on an interface:
To do...
Enter system view
Enter interface view
Configure an MLD version on the
interface
Use the command...
system-view
multicast ipv6 routing-enable
interface interface-type interface-number
mld enable
.
Use the command...
system-view
mld
version version-number
Use the command...
system-view
interface interface-type interface-
number
mld version version-number
Remarks
—
—
Optional
MLDv1 by default
Remarks
—
—
Optional
MLDv1 by default
309
Remarks
—
Required
Disable by default
—
Required
Disabled by default
IP Multicast