Sa Message Filtering Configuration - HP A5500 SI Switch Series Configuration Manual

Upstream interface: Vlan-interface104
Upstream neighbor: 10.110.4.2
RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200

SA message filtering configuration

Network requirements
As shown in
•
the domains to provide unicast routing.
Configure Loopback 0 of Switch A, Switch C, and Switch D as a C-BSR and C-RP in the respective
•
PIM-SM domain.
Set up an MSDP peering relationship between Switch A and Switch C and between Switch C and
•
Switch D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source
•
2 sends multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the
•
multicast data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Host C can
receive only the multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.
Figure 61 Network diagram for SA message filtering configuration
Device
Source 1
Source 2
Switch A
Protocol: pim-sm, UpTime:
Figure 61, the network has three PIM-SM domains, and OSPF runs within and among
Interface IP address
— 10.110.3.100/24
— 10.110.6.100/24
Vlan-int100 10.110.1.1/24
Vlan-int102 10.110.2.1/24
Vlan-int101 192.168.1.1/24
- , Expires: -
Device Interface
Switch C Vlan-int300
Vlan-int104
Vlan-int101
Vlan-int103
Loop0
215
IP address
10.110.4.1/24
10.110.5.1/24
192.168.1.2/24
192.168.2.2/24
2.2.2.2/32