Configuring Ipv6 Multicast Source Port Filtering - HP A5500 SI Switch Series Configuration Manual

IPv6 multicast data that fails the ACL check is not sent to this port. In this way, the service provider can
control the VOD programs provided for multicast users.
Configuring an IPv6 multicast group filter globally
Follow these steps to configure an IPv6 multicast group globally:
To do...
Enter system view
Enter MLD snooping view
Configure an IPv6 multicast group
filter
Configuring an IPv6 multicast group filter on a port or a group of ports
Follow these steps to configure an IPv6 multicast group filer on a port or a group of ports:
To do...
Enter system view
Enter Ethernet interface view,
Layer 2 aggregate interface view,
or port group view
Configure an IPv6 multicast group
filter

Configuring IPv6 multicast source port filtering

When the IPv6 multicast source port filtering feature is enabled on a port, the port can connect only to
IPv6 multicast receivers rather than multicast sources. The reason is that the port blocks all IPv6 multicast
data packets but it permits multicast protocol packets to pass.
If this feature is disabled on a port, the port can connect to both multicast sources and IPv6 multicast
receivers.
Configuring IPv6 multicast source port filtering globally
Follow these steps to configure IPv6 multicast source port filtering:
To do...
Enter system view
Enter MLD snooping view
Enable IPv6 multicast source port
filtering
Use the command...
system-view
mld-snooping
group-policy acl6-number [ vlan
vlan-list ]
Use the command...
system-view
interface interface-type interface-
number
port-group manual port-group-
name
mld-snooping group-policy acl6-
number [ vlan vlan-list ]
Use the command...
system-view
mld-snooping
source-deny port interface-list
256
Remarks
—
—
Required
By default, no IPv6 group filter is
globally configured. That is, the
hosts in a VLAN can join any
valid multicast group.
Remarks
—
Required
Use either approach
Required
By default, no IPv6 group filter is
configured on an interface. That
is, the hosts on the interface can
join any valid multicast group.
Remarks
—
—
Required
Disabled by default