HP A5500 SI Switch Series Configuration Manual page 179

Switch C
Configuration procedure
Configure IP addresses and unicast routing.
1.
Configure the IP address and subnet mask for each interface according to
Configure OSPF on the switches in the PIM-SM domain to ensure network-layer reachability among them
(details not shown).
Enable IP multicast routing, and enable PIM-SM and IGMP.
2.
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and enable IGMP on
VLAN-interface 100, which connects Switch A to the stub network.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim sm
[SwitchA-Vlan-interface102] quit
The configuration on Switch B and Switch C is similar to that on Switch A. The configuration on Switch D
and Switch E is also similar to that on Switch A except that it is not necessary to enable IGMP on the
corresponding interfaces on these two switches.
Configure a C-BSR and a C-RP.
3.
# On Switch D, configure the service scope of RP, specify a C-BSR and a C-RP, and set the hash mask
length to 32 and the priority of the C-BSR to 10.
<SwitchD> system-view
[SwitchD] acl number 2005
[SwitchD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchD-acl-basic-2005] quit
[SwitchD] pim
[SwitchD-pim] c-bsr vlan-interface 105 32 10
[SwitchD-pim] c-rp vlan-interface 105 group-policy 2005
[SwitchD-pim] quit
# On Switch E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and set
the hash mask length to 32 and the priority of the C-BSR to 20.
<SwitchE> system-view
[SwitchE] acl number 2005
[SwitchE-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchE-acl-basic-2005] quit
[SwitchE] pim
Vlan-int103 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Vlan-int104 192.168.3.1/24
Vlan-int103
Vlan-int102
Vlan-int105
167
192.168.2.2/24
192.168.9.2/24
192.168.4.1/24
Figure 50 (details not shown).