HP A5500 SI Switch Series Configuration Manual page 117

Figure 34 Network diagram for IGMP SSM mapping configuration
Device
Source 1
Source 2
Switch A
Switch B
Configuration procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask of each interface according to
configuration steps are omitted here.
Configure OSPF for interoperability among the switches. Ensure the network-layer interoperation on the
PIM-SM domain and dynamic update of routing information among the switches through a unicast
routing protocol. The detailed configuration steps are omitted here.
Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
2.
mapping on the host-side interface.
# Enable IP multicast routing on Switch D, enable PIM-SM on each interface, and enable IGMPv3 and
IGMP SSM mapping on VLAN-interface 400.
<SwitchD> system-view
[SwitchD] multicast routing-enable
[SwitchD] interface vlan-interface 400
[SwitchD-Vlan-interface400] igmp enable
[SwitchD-Vlan-interface400] igmp version 3
[SwitchD-Vlan-interface400] igmp ssm-mapping enable
[SwitchD-Vlan-interface400] pim sm
[SwitchD-Vlan-interface400] quit
[SwitchD] interface vlan-interface 103
[SwitchD-Vlan-interface103] pim sm
[SwitchD-Vlan-interface103] quit
[SwitchD] interface vlan-interface 104
Interface IP address
— 133.133.1.1/24
— 133.133.2.1/24
Vlan-int100 133.133.1.2/24
Vlan-int101 192.168.1.1/24
Vlan-int104 192.168.4.2/24
Vlan-int200 133.133.2.2/24
Vlan-int101 192.168.1.2/24
Vlan-int102 192.168.2.1/24
Device Interface
Source 3 —
Receiver —
Switch C Vlan-int300
Vlan-int103
Vlan-int102
Switch D Vlan-int400
Vlan-int103
Vlan-int104
105
IP address
133.133.3.1/24
133.133.4.1/24
133.133.3.2/24
192.168.3.1/24
192.168.2.2/24
133.133.4.2/24
192.168.3.2/24
192.168.4.1/24
Figure 34. The detailed