HP A5500 SI Switch Series Configuration Manual page 190

Figure 52 Network diagram for BIDIR-PIM configuration
Device Interface
Switch A Vlan-int100
Vlan-int101
Switch B Vlan-int200
Vlan-int101
Vlan-int102
Switch C Vlan-int102
Vlan-int103
Loop0
Configuration procedure
Configure IP addresses and unicast routing.
1.
Configure the IP address and subnet mask for each interface according to
Configure OSPF on the switches in the BIDIR-PIM domain to ensure network-layer reachability among
them (details not shown).
Enable IP multicast routing, PIM-SM, BIDIR-PIM, and IGMP.
2.
# On Switch A, enable IP multicast routing, enable PIM-SM on each interface, and enable BIDIR-PIM.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] pim
[SwitchA-pim] bidir-pim enable
[SwitchA-pim] quit
IP address Device
192.168.1.1/24 Switch D
10.110.1.1/24
192.168.2.1/24
10.110.1.2/24 Source 1
10.110.2.1/24 Source 2
10.110.2.2/24 Receiver 1
10.110.3.1/24 Receiver 2
1.1.1.1/32
178
Interface IP address
Vlan-int300 192.168.3.1/24
Vlan-int400 192.168.4.1/24
Vlan-int103 10.110.3.2/24
- 192.168.1.100/24
- 192.168.4.100/24
- 192.168.2.100/24
- 192.168.3.100/24
Figure 52 (details not shown).