HP A5500 SI Switch Series Configuration Manual page 215

Each PIM-SM domain has zero or one multicast source and receiver. OSPF runs within each
•
domain to provide unicast routes.
Loopback 0 of Switch B, Switch C, and Switch E must be configured as the C-BSR and C-RP of the
•
PIM-SM domains respectively.
An MSDP peering relationship must be set up between Switch B and Switch C through eBGP, and
•
between Switch C and Switch E through iBGP.
Figure 58 Network diagram for inter-AS multicast configuration leveraging BGP routes
Device
Switch A
Switch B
Switch C
Configuration procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface according to
Configure OSPF for interconnection between switches in each AS. Ensure the network-layer
interoperation among each AS, and ensure the dynamic update of routing information between the
switches through a unicast routing protocol (details not shown).
Enable IP multicast routing, enable PIM-SM on each interface, and configure a PIM-SM domain
2.
border
Interface IP address
Vlan-int103 10.110.1.2/24
Vlan-int100 10.110.2.1/24
Vlan-int200 10.110.3.1/24
Vlan-int103 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Vlan-int104 10.110.4.1/24
Vlan-int102 192.168.3.1/24
Vlan-int101 192.168.1.2/24
Loop0 2.2.2.2/32
Device Interface
Switch D Vlan-int104
Vlan-int300
Switch E Vlan-int105
Vlan-int102
Loop0
Switch F Vlan-int105
Vlan-int400
Source 1 —
Source 2 —
203
IP address
10.110.4.2/24
10.110.5.1/24
10.110.6.1/24
192.168.3.2/24
3.3.3.3/32
10.110.6.2/24
10.110.7.1/24
10.110.2.100/24
10.110.5.100/24
Figure 58 (details not shown).