Multicast Models; Multicast Architecture - HP A5500 SI Switch Series Configuration Manual

Communication for training and cooperative operations, such as distance learning and
•
telemedicine
Data warehouse and financial applications, such as stock quotes
•
Any other point-to-multipoint applications for data distribution
•

Multicast models

Based on how the receivers treat the multicast sources, the multicast models include any-source multicast
(ASM), source-filtered multicast (SFM), and source-specific multicast (SSM).
ASM model
In the ASM model, any sender can send information to a multicast group as a multicast source, and
numbers of receivers can join a multicast group (identified by a group address) and can obtain multicast
information addressed to that multicast group. In this model, receivers do not determine the positions of
the multicast sources in advance. However, they can join or leave the multicast group at any time.
SFM model
The SFM model is derived from the ASM model. To a sender, the two models appear to have the same
multicast membership architecture.
The SFM model functionally extends the ASM model. The upper-layer software checks the source address
of received multicast packets and permits or denies multicast traffic from specific sources. Therefore,
receivers can receive the multicast data from only part of the multicast sources. To a receiver, not all
multicast sources are valid: they are filtered.
SSM model
Users might be interested in the multicast data from only certain multicast sources. The SSM model
provides a transmission service that enables users to specify the multicast sources that they are interested
in at the client side.
The main difference between the SSM model and the ASM model is that in the SSM model, receivers
have already determined the locations of the multicast sources by some other means. In addition, the
SSM model uses a multicast address range that is different from that of the ASM/SFM model, and
dedicated multicast forwarding paths are established between receivers and the specified multicast
sources.

Multicast architecture

IP multicast addresses the following questions:
Where should the multicast source transmit information to? (multicast addressing)
•
What receivers exist on the network? (host registration)
•
Where is the multicast source that will provide data to the receivers? (multicast source discovery)
•
How should information be transmitted to the receivers? (multicast routing)
•
IP multicast is an end-to-end service. The multicast architecture involves the following parts:
Addressing mechanism—A multicast source sends information to a group of receivers through a
1.
multicast address.
Host registration—Receiver hosts can join and leave multicast groups dynamically. This mechanism
2.
is the basis for management of group memberships.
5