Data Initialization Function - Brother S-7000DD Service Manual

2-3. Data initialization function

NOTE:
If the slide switch (SW1) on the main P.C. board has been moved to a position other than the middle position, initialization
cannot be carried out.
Move the slide switch (SW1) to the middle position (factory default position) and then carry out the following operations.
(Refer to "3. SLIDE SWITCH (SW1) SETTING METHOD" for details on the slide switch.)
Change to initialization mode
1
(While pressing the continuous backtack key, press the power ON switch.)
Initialization item
display
1 [1.ALL]
2 [2.MEM]
3 [3.SPD]
4 [4.SEW]
Select the initialization item
2
Initialization item
Carry out initialization
3
(Press for 2 seconds or more.)
4
Clear all
(items 2, 3 and 4 will be initialized.)
Memory switches
Sewing speed settings (Maximum sewing speed, start backtack sewing speed)
Settings for memory switches F180 to F189
Sewing programs
Backtacking function, stitch number settings, counter initialization settings and
counter values, basic function settings
• When the D
displayed.
• When the C
previous initialization item.
NOTE:
Function setting mode will be exited and normal operation will be possible.
(If you would like to cancel initialization, set the power switch to OFF.)
S-7000DD
2. FUNCTION SETTINGS (OPERATION PANEL)
"1.ALL" will appear in the display (1).
Initialization item
key is pressed, the next initialization item is
key is pressed, the display returns to the
After "END" is displayed, press the C
return the display to the initialization item.
or D key to
26