Brother S-7000DD Service Manual page 26

2. FUNCTION SETTINGS (OPERATION PANEL)
Specifications and destination settings (950-)
Setting
No.
range
OFF/
F950
1 - 9
OFF/
F951
1 - 2
F952 OFF/1
F953 OFF/1
OFF/
F954
1 - 4
300 -
F955 4500
(sti/min)
(sti/min)
300 -
F956 4500
(sti/min)
(sti/min)
17
Initial Setting
value units
OFF 1
OFF 1
OFF 1
OFF 1
OFF 1
1000
100
3000
100
Option input 1 function (manual option switch)
OFF: Function not available
1: Lower thread counter reset switch
* Option output 1 outputs counter warning signals.
2: End backtacking single cancel switch
* Option output 1 outputs end backtacking cancel signals.
3: Speed selection high-speed switch
4: Half-stitch correction switch
5: Single stitch correction switch
6: Reverse correction switch
7: Thread trimming switch
8: Work clamp lifter switch (alternate operation)
9: Work clamp lifter switch (momentary operation)
Option input 2 function
OFF: Function not available
* When F950 is set to "3", functions as a speed selection switch for
medium speed.
1: Operation prohibition input (operation by operating the pedal at Low,
etc. is prohibited )
2: Variable input for optional solenoid
* This is enabled when F960 is set to "7".
Option input 3 setting
* When F950 is set to "3", the following settings are disabled.
OFF: Function not available (When F950 is set to other than "3")
Speed selection low-speed switch (When F950 is set to "3")
1: Low-speed operation limit input (Limits the sewing speed using the
pedal to low speed at Low setting)
Option output 1 setting
* When F950 is set to "1" or "2", the following settings are disabled.
OFF: Function not available (When F950 is set to other than "1" or "2")
Lower thread counter warning signal output (When F950 is set to
"1")
End backtacking cancel signal output (When F950 is set to "2")
1: Error signal (Output ON when error is generated)
Option output 2 setting
OFF: Function not available
1: Thread trimming solenoid signal (Output ON when thread trimming
solenoid is ON)
2: Quick reverse solenoid signal (Output ON when quick reverse solenoid
is ON)
3: Work clamp lifter solenoid signal (Output ON when work clamp lifter
solenoid is ON)
4: Automatic backtacking output signal (Output ON during automatic
backtacking)
Sewing speed when low-speed operation switch is pressed
* This is enabled when F950 is set to "3".
NOTE: The actual operating speed will be limited by the maximum
sewing speed setting.
Sewing speed when medium-speed operation switch is pressed
* This is enabled when F950 is set to "3".
NOTE: The actual operating speed will be limited by the maximum
sewing speed setting.
S-7000DD
Setting details