Brother S-7000DD Service Manual page 25

Error processing settings (650-)
Setting
No.
range
OFF/
F650
2 - 30
(seconds)
1 - 30
F651
(minutes)
F652
ON/OFF
Specifications and destination settings (850-)
Setting Initial
No.
range value
F851 ON/OFF
F852 ON/OFF
F890
0 - 1
(*2)
(*1) This is not initialized during initialization mode.
(*2) Not displayed for -[ ]05 specifications.
Initial Setting
value units
OFF 1
3
1
(minutes)
ON -
Setting
units
Treadle operation specifications
ON: Specifications for Europe and the Americas
OFF
-
(*1)
OFF: Other specifications
Presser foot lowering at the forward 1st step
OFF
- ON: Enabled
(*1)
OFF: Disabled
0 1 [Do not change this setting.]
2. FUNCTION SETTINGS (OPERATION PANEL)
Time from error display to buzzer stopping (seconds)
OFF: Buzzer does not stop.
2-30: Buzzer stops after the specified time.
Overtime error display
1-30: After continuous operation for the set length of time, operation stops
and [E190] is displayed.
Needle up stop error display
* An error is not displayed when the setting for thread wiping " WIP" is
"OFF".
OFF: None
ON: If the needle does not stop at the up position after thread trimming,
[E111] is displayed.
・ If F001 is "OFF"
When the treadle is returned to the neutral position after thread
trimming, the presser foot is lowered.
* If the treadle is returned to the neutral position during thread
trimming, the presser foot does not rise.
・ If F001 is "ON"
After thread trimming, the presser foot rises.
The presser foot does not drop even when the treadle is returned to
the neutral position.
・ If F001 or F002 is "ON"
Even after the treadle has been depressed to the 1st step and the
presser foot has dropped, the presser foot rises when the treadle is
returned to the neutral position.
NOTE:
If F852 and F057 are not both "ON" at the same time, the presser
foot lowering function at the treadle's 1st step will be disabled.
・ The presser foot does not drop even when the treadle is returned to
the neutral position after thread trimming.
・ When the treadle is depressed backward or the knee switch changes
from ON to OFF, the presser foot drops.
NOTE:
The presser foot does not rise at the treadle neutral position
regardless of the settings for F001 and F002.
S-7000DD
Setting details
Setting details
16