Setting Method For Standard Depression Strokes - Brother S-7000DD Service Manual

4. SETTING METHOD FOR STANDARD DEPRESSION STROKES

4. SETTING METHOD FOR STANDARD DEPRESSION STROKES
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
Use the following procedure to set the operating positions for the depression stroke.
NOTE: If the slide switch (SW1) on the main P.C. board has been moved to a position other than the middle position,
initialization cannot be carried out. Move the slide switch (SW1) to the middle position (factory default position) and
then carry out the following operations.
(Refer to "3. SLIDE SWITCH (SW1) SETTING METHOD" for details on the slide switch.)
Change to treadle position adjustment mode
1
(While pressing the C
Store the maximum forward depression amount
2
(With the treadle depressed to the maximum forward position, press the SEL key.)
Store the neutral position
3
(With your foot released from the treadle, press the SEL key.)
Store the maximum backward depression amount
4
(With the treadle depressed to the maximum backward position, press the SEL key.)
41
key, press the power ON switch.)
DANGER
"FF x.x" will appear in the display (1).
("x.x" indicates the treadle voltage.)
"NN x.x" will appear in the display (1).
"RR x.x" will appear in the display (1).
"PD --" will appear in the display (1).
S-7000DD