4-Digit Display Switching Method (F470="On"); Switching To Number Of Backtack; Stitches Display (F470="On") - Brother S-7000DD Service Manual

2-2-3. 4-digit display switching method (F470="ON")

・ The 4-column data in the display (2) can be changed to one of the following three statuses each time the SEL key (1) is
pressed.
Pattern display → Sewing speed display → Counter display
・ The display can be changed to another value by pressing the FUNC key (3).
・ The sewing speed setting method and the counter setting method are the same as when F470 is set to "OFF".
(Refer to "4-2. Speed setting method" and "4-3. Counter setting method" in the instruction manual.)
Display mode
Pattern display
No. of backtack
stitches display
Number of step
stitches display
Sewing speed
display
Counter display
2-2-4. Switching to number of backtack stitches display and number of step stitches
display (F470="ON")
・ The pattern display will appear immediately after the power switch is set to "ON".
・ The display can be changed to the following displays by pressing the FUNC key (3).
Pattern display → Number of backtack stitches display → Number of step stitches display
* There is no number of step stitches display for pattern 1.
* If any of the indicators for the start backtacking, end backtacking and continuous backtacking keys are illuminated, you
can switch to number of backtacking stitch display. If all indicators are switched off, this display will be skipped.
(2)
(1)
ON
ON
ON
Flashing
ON ON
ON
Flashing
S-7000DD
2. FUNCTION SETTINGS (OPERATION PANEL)
(3)
4-digit display
Pattern and step display
ON ABCD stitch number display
Flashing Number of step stitches display
Maximum sewing speed setting
value
Start backtack sewing speed
ON
setting value
Lower thread counter value
Lower thread counter warning
enabled
Thread trimming counter value
Needle replacement counter
ON
value
Needle replacement counter
Flashing
warning enabled
20