Brother S-7000DD Service Manual page 19

Panel operation settings (300-)
Setting
No.
range
F300 1 - 3
0 - 100
F301
(stitches) (stitches)
F302 0 - 2
0 - 1000
F303
(stitches) (stitches)
F305 ON/OFF
F310 1 - 2
F311 1 - 5
F312 1 - 5
F313 ON/OFF
Initial Setting
value units
Main counter display
1 1
1: Lower thread counter (Counting units are set by F301.)
2: Thread trimming counter (incremented by 1 each time of a thread
3: Needle replacement counter (Counting units are set by F303.)
Lower thread counter counting units
10
1 0: No counting operation
1-100: Display counts down by the set number of stitches
Operation for counter warning (when < ! > warning icon is displayed)
0: Starting using the treadle is always enabled
1: After thread trimming stops, starting using the treadle is disabled.
1 1
2: Operation using treadle fully disabled after treadle is returned to neutral
Needle replacement counter counting units
100
10 0: No counting operation
10-1000: Display counts down by the set number of stitches
Switching the counter display at the sewing start
ON: Remains at counter display
ON -
OFF: Switches from counter display to stitch number display (When F470
4-digit display operation when the SEL key is pressed
1: No display → Stitch number display → Counter display → Sewing speed
1 1
2: No display → Sewing speed display → Counter display → Stitch number
F1 function setting
* The same function as F312 cannot be selected.
1: Needle up/down
4 1
2: Correction
3: Slow start
4: Thread trimming disable
5: Thread wiping
F2 function setting
* The same function as F311 cannot be selected.
1: Needle up/down
3 1
2: Correction
3: Slow start
4: Thread trimming disable
5: Thread wiping
Automatic operation during continuous backtack sewing (When F470 is
"OFF")
OFF -
ON: AUTO operation enabled
OFF: AUTO operation disabled
2. FUNCTION SETTINGS (OPERATION PANEL)
* Initial display item when switching the display using the SEL key
Changes in the order 1→2→3→1→... each time the FUNC key is
pressed.
trimming operation occurs)
* The counter is incremented even if thread trimming is set to disabled.
(enabled until depressed backward)
position and sewing stops
* To switch to a display other than the counter display, press the
SEL key.
is set to "OFF")
Returns to pattern display (When F470 is set to "ON")
display
display
S-7000DD
Setting details
10