Brother S-7000DD Service Manual page 41

<Output check list>
The display on the operation panel shows the item number/item name or the output status.
Item no. Item name
[ 1] [ TRM]
[ 2] [ WIP]
[ 3] [ REV]
[ 4] [ PRE]
[ 5] [ OPT]
[ 6] [INCH]
[ 7] [TRIM]
[ 8] [SLOW]
[ 9] [ SBT]
[ 10] [ EBT]
[ 11] [HIGH]
[ 12] [AUTO]
[ 13] [ POS]
Output status
Thread trimming solenoid
Off
Thread wiper solenoid
Off
Quick reverse solenoid
Off
Work clamp lifter solenoid
Off
Work clamp lifter solenoid
Off
Inching speed operation
Thread trimming speed operation
Slow speed operation
Start backtack sewing speed operation
[****] [sti/min]
End backtack sewing speed operation
Shows the actual
sewing machine
speed
High speed operation
Automatic speed operation
Stop improvement speed operation
2. FUNCTION SETTINGS (OPERATION PANEL)
Check item and checking method
When the treadle is depressed, the solenoid operates for 0.5 second.
When the treadle is returned to the neutral position, the signal turns
off.
When the treadle is depressed, the solenoid operates.
When the treadle is returned to the neutral position, the signal turns
off.
When the treadle is depressed, the solenoid operates for 0.5 second.
When the treadle is returned to the neutral position, the signal turns
off.
When the treadle is depressed, the solenoid operates for 0.5 second.
When the treadle is returned to the neutral position, the signal turns
off.
When the treadle is depressed, the solenoid signal turns on for 0.5
second.
When the treadle is returned to the neutral position, the signal turns
off.
When the treadle is depressed, the upper shaft rotates at the inching
speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at the thread
trimming speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at slow
speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at the start
backtack sewing speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at the end
backtack sewing speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at a speed
corresponding to the treadle depression amount (inching speed to
maximum speed).
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at the
automatic speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
When the treadle is depressed, the upper shaft rotates at the stop
improvement speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
S-7000DD
(Continued on next page)
32