Number Of Step Stitches Display Mode (F470="On") - Brother S-7000DD Service Manual

2. FUNCTION SETTINGS (OPERATION PANEL)

2-2-7. Number of step stitches display mode (F470="ON")

・ You can switch to this display when the number of stitches for each step have been set.
・ If the start backtack, end backtack or continuous backtack keys are pressed so that the corresponding indicator
illuminates, you can switch to the number of backtacking stitch display.
* For a pattern other than pattern 1, when the continuous backtack key is pressed so that the indicator illuminates, the
pattern will change to pattern 1. In this case, the pattern display will change to "1- ".
・ If the start backtack or end backtack keys are pressed so that the indictors mentioned previously are switched off, the
display will switch to pattern display.
[Patterns 2 to 4]
Step switching (Pattern 3 only)
[Patterns 5 to 9]
・ The thread trimming disable/F1 key can be used to set the automatic thread trimming function. (Setting is possible for
patterns 2 to 9.)
If you press the key so that the indicator illuminates, automatic thread trimming will be enabled.
After the number of stitches which have been set (start and end backtacking, fixed sewing) have been sewn, thread
trimming will be carried out automatically. Sewing will be carried out automatically for the number of stitches which have
been set (start and end backtacking, fixed sewing, thread trimming) simply by depressing the treadle once.
* For pattern 4, setting is possible when memory switch F405 is set to "ON".
* For patterns 5 to 9, the setting can be made for each step.
・ The AUTO function can be set using the slow start/F2 key. (For pattern 1, the AUTO function can be set when the
indicator in the continuous backtack key is illuminated.)
If you press the key so that the indicator illuminates, the AUTO function will be enabled.
Sewing will be carried out automatically for the number of stitches which have been set (start and end backtacking, fixed
sewing, thread trimming) simply by depressing the treadle once.
* For pattern 4, setting is possible when memory switch F405 is set to "ON".
* For patterns 5 to 9, the setting can be made for each step.
NOTE:
The thread trimming disable and slow start functions cannot be set in this display mode.
Press the FUNC key to switch to pattern display before making these settings.
23
Step (E or F)
Step (1 to 20)
Step - 1
Step + 1
S-7000DD
Number of step stitches (0 to 99)
Stitch number setting + 1
Stitch number setting - 1
Number of step stitches (0 to 99)
Stitch number setting + 1
Stitch number setting - 1
Switches to pattern
display
Switches to pattern
display