Re-Installing The Development Unit - Ricoh D131 Service Manual

Main Machine

Re-installing the Development Unit

1. Push the development unit to the right
2. While continuing to hold the unit to the right, push it into the machine.
3. Confirm that the pin [A] goes into the left side of the oval hole [B] in the development unit
plate.
4. Push the development unit in completely
5. Make sure you can see the horizontal pin in front of the plate as shown below.

If you cannot move the development unit plate behind the horizontal pin, turn the
front gear of the unit to the left and try again.
6. Make sure the pipeline shutter is rotated down to the open position.
7. Reattach all removed parts.
D131/D132/D133
.
until it stops, then push it to the left
2-14
.
SM